Engine almost ready for reinstallation.
Belts tensioned and balance shaft positions set
Here you can see the turbo mounting and the oil line setup
to feed the turbo and the line back to the oil pan. The inlet for
the turbo is shown here in the wrong orientation, the housing needs to
be rotated such the the inlet points downward.
Time to put on the clutch and bell housing and its back
in the car
Picture of the engine back where it belongs, some of the
intercooler ducting can bee seen.
Poor picture of the location of the intercooler, the front spoiler was notched to allow for it to clear. The new valance is a later one which will not require cutting.