From: Wally Plumley [wplumley@bellsouth.net]
Sent: Wednesday, August 30, 2000 12:54 PM
To: Callahan, Larry
Subject: Re: [928OC Public] Tech Question :

At 12:54 PM 8/24/00 -0700, you wrote:
>How do I remove the cover, on the center console, under my AT shifter?


I'm glad that you asked instead of breaking it, as most people do!


To Remove:

Remove the shift handle and rubber boot.

Put lever in "2" and push rear locking bar forward against stop with a scribe.

Put lever in "R", disconnect gate and push as far forward as possible.

Push front locking bar forward against stop with a scribe.

Put lever in "P" and carefully pop out left rear corner of the cover frame.

Put lever in "N" and remove cover and frame to the rear.


To Install:

Put lever in "3".

Push gate in frame forward all the way.

Insert cover and frame, and move lever to "P".

Lift left rear corner slightly and insert right and front of cover and 
frame, then push down on left rear.

Put lever between "R" and "P", disconnect gate on selector lever and push 
forward.

Push front locking bar toward rear until it locks.

Put lever in "3" and push rear locking bar back until it locks.

Reinstall gate, rubber boot and shift handle.

Wally Plumley
928 Specialists

----------
This list is a public service provided free by the members of the 928 Owners Club for all 928 owners. 

Join today and help support this list and the 928 OWNERS CLUB http://www.928oc.org!
----------
For 928 List Help, send the following e-mail:

To: imailsrv@list.928oc.org 
Subject:(leave blank) 
Body: Help 928