From: John Pirtle [john.pirtle@rennlist.com]
Sent: Tuesday, April 22, 2003 9:33 PM
To: 928
Subject: [928] RE: Suspension issues

...

Probably not your primary issue, but while you are checking -
Workshop Manual pg 40-11 description of part #23 Hex bolt: "coat thread with
Optimoly HT (Optimoly HT on bolt shank is impermissible).  Screw in until
only 2 threads are visible.  Do not tighten to 120 Nm (88 ftlb) until
assembly is completed and springs have settled."

This hex bolt 23 are the two bolts attaching the "bearing clamp" to the rear
end of the lower control arm.  This is the aluminum bracket that you also
measure front ride height with (has a flat dimple on the bottom).

The other 2 hex bolts attaching the "guard" to the front end of the lower
control arm are torqued to 85 Nm (62 ftlb), no suspension settling needed.

...